top of page

SERIES 9

Zatáčkový a spirálový modulární pás I Rozteč modulů 50 mm (1.97 in)

Pro středně těžké až těžké potravinářské i nepotravinářské aplikace

Design characteristics

  • Suitable for both straight and radius conveying

  • 57 % open area for excellent air circulation and drainage

  • Stainless steel hinge pins for high load capacity, lateral stiffness, less belt supports and minimum belt lifting in curves

  • No potential belt edge catch points due to safe fixing of hinge pin

S9_EN.jpg

Basic data

 

Pitch

 

Belt width min.

Width increments

 

Hinge pins

 

50 mm (1.97 in)

 

100 mm (3.9 in)

50 mm (1.97)

Stainless steel

Series 9.jpg

S9-57 GRT | 57% Opening | Grid top

 

  • Open area (57 %) for excellent air circulation and drainage

  • Lattice-shaped surface

S9-57 GRT.jpg

S9-57 NTP | 57% Opening | Nub top (round studs)

 

  • Open area (57 %) for excellent air circulation and drainage

  • Lattice-shaped surface with 3.0 mm (0.12 in) high round studs 4 % contact area

  • Nub top surface for increased grip and reduced contact area for good release

S9-57 NTP.jpg

S9-57 GRT G | 57% Opening | Grid top · guided

 

  • Open area (57 %) for excellent air circulation and drainage

  • Lattice-shaped surface

  • Guided version (G) allows utilisation
    of the entire belt width

S9-57 GRT G.jpg

S9-57 NTP G | 57% Opening | Nub top (round studs) · guided

 

  • Open area (57 %) for excellent air circulation and drainage

  • With round studs for increased grip (4 % contact area)

  • Guided version (G) allows utilisation of the entire belt width

S9-57 NTP G.jpg

S9-57 GRT F2, F3, F4, F5, F6, F7, F8 | 57% Opening

 

  • Open area (57 %) for excellent air circulation and drainage

  • Special edge modules with noses (F2 –F8) of varying size ensure smooth belt operation when the system turn radius is greater than the minimum belt turn radius

S9-57 GRT F2.jpg

Sprockets

 

In different sizes with round or square sprocket bore

s9_sprocket.jpg

Profiles

 

in different heights and designs for inclines

s9_profile.jpg

Side guards

 

in different heights for retention of bulk products

s9_sideguard.jpg
bottom of page